Enduro.cy
Sur-Ron Light Bee 2 X

SUR-RON · 2026 · OFF-ROAD

Light Bee 2 X.

Studio view of the Sur-Ron Light Bee 2 X

The second-generation off-road Light Bee uses a one-piece forged frame and a semi-solid-state battery. A dedicated lever controls regenerative braking on descents.

Peak power
24 kW
Top speed
90 km/h
Kerb weight
65 kg
Ask price & availability

Inside the Light Bee 2 X.

The X is the 65 kg trail version of the second-generation Light Bee. Its electronics let you set how sharply the motor responds on the way up and how much the bike slows when you close the throttle on the way down.

In this guide
Copper hairpin windings around the Light Bee 2 motor stator.

Where the 410 N·m comes from

The EVO-2 motor sits in the frame. Inside its stator, flat copper windings pack closely into the slots. Oil circulates around the windings and magnets to carry away heat during a sustained climb. The motor itself weighs 6.5 kg.

A two-stage gear reduction multiplies motor torque before a sealed 520 chain takes drive to the rear wheel. Sur-Ron measures peak torque at that wheel. The production bike delivers up to 24 kW, with a quoted 0–50 km/h time of 1.8 seconds.

Peak output
24 kW
Rear-wheel torque
410 N·m
Cutaway of the Light Bee 2 reduction gears and final-drive sprocket.

Inside the reduction gearbox

The EVO-2 drive unit houses the reduction gears. They lower motor speed before the final chain drives the rear wheel, where peak torque reaches 410 N·m.

Packing energy into 14.9 kg

Sur-Ron and Qingtao Energy developed a semi-solid-state battery for the Light Bee 2. It stores 3.53 kWh and lifts out for charging. Energy density is 237 Wh/kg for the complete pack, including its housing and electronics. Sur-Ron gives a separate figure of up to 320 Wh/kg for the cells.

The enclosure carries an IP67 rating. When the bike is stored, a sleep mode limits the energy the pack uses while idle.

Pack voltage
78.54 V
Capacity
45 Ah
Pack weight
14.9 kg

Charging between rides

The charger fits under the seat. Its rated output is 1,000 W, with adjustable settings from 400 W to a peak of 1,200 W. The battery can stay in the bike or be taken indoors to charge.

Sur-Ron quotes two hours to go from 20% to 80%. That covers the middle 60% of the pack, a useful figure when deciding whether there is time to top up between rides.

From 20% to 80%
2 h
Rated charger output
1,000 W
The Light Bee 2 battery pack shown in cutaway.

Range at two riding speeds

Sur-Ron tested the 3.53 kWh battery at two steady speeds. The bike covered up to 160 km at 25 km/h and up to 108 km at 40 km/h. Trail conditions and rider weight affect actual range.

How test speed changes range

Steady 25 km/h
160 km
Steady 40 km/h
108 km

Maximum distances published by Sur-Ron. For the 40 km/h test, a 70 kg rider rode on a dry, level road at 27°C. Climbs, loose ground and repeated acceleration change the result.

A Light Bee 2 X rider follows a rocky trail through woodland.
A rider using the Light Bee 2 handlebar controls on a rocky trail.

Choosing a response for the trail

Eco, Daily, Sport and Turbo offer preset responses. Crawl gives you a low-speed option for tight sections, and Reverse helps when you need to back the bike out. Custom is the seventh mode.

The SRTC traction control has three settings for rear-wheel slip. Throttle response also has three settings. These are separate adjustments, so you can keep a gentler response at the grip while changing how the bike handles a loose surface.

Ride modes
7
Traction settings
3
Throttle settings
3

A forged chassis and progressive rear travel

The frame and swingarm are forged aluminium. Compared with the original Light Bee, Sur-Ron reports a 50% increase in frame strength and twice the swingarm’s torsional rigidity. The latter describes resistance to twisting when the rear wheel takes a sideways load.

The rear shock moves 85 mm. The linkage translates that into 220 mm at the wheel, with less resistance early in the stroke for small bumps and more support deeper in the travel. Ground clearance is 280 mm.

Shock stroke
85 mm
Rear-wheel travel
220 mm
Ground clearance
280 mm
A rider takes a Light Bee 2 X across a rocky trail.

38 mm fork for rough ground

The 38 mm fork tubes provide 215 mm of travel. At the rear, the linkage moves the wheel through 220 mm, with more resistance near the end of its stroke for hard landings.

Chassis dimensions

Wheelbase
1280 mm
Seat Height
830 mm
Ground Clearance
280 mm
Opposed four-piston brake caliper mounted alongside the Light Bee 2 disc.

Two ways to slow the bike

Coasting regeneration sets how strongly the motor slows the bike when you close the throttle. A dedicated trigger calls for regeneration separately. Each has five settings, so you can have light drag while coasting and ask for more with one finger.

The hydraulic brakes use opposing four-piston calipers and sintered pads. The 220 mm front disc handles the larger share of braking as weight shifts forward. The rear disc measures 203 mm.

Front disc
220 mm
Rear disc
203 mm

The cockpit and the off-road equipment

The X has a fixed-beam, 3,100-lumen trail headlight. It comes without the mirrors and indicators fitted to the L3. The 2.86-inch colour display is laminated to reduce reflections in sunlight, and Sur-Ron quotes peak brightness of 1,000 nits.

An 18 W USB-C outlet lets you power a phone or action camera at the handlebar. The under-seat compartment takes the compact charger, leaving the rear mounting points available for luggage.

Trail headlight
3,100 lm
TFT display
2.86 in
USB-C output
18 W

Technical specifications.

Size and geometry

Dimensions
1900 × 790 × 1080 mm
Wheelbase
1280 mm
Seat Height
830 mm
Kerb Weight
65 kg
Load capacity
100 kg
Ground Clearance
280 mm
Front Fork Travel
215 mm
Rear Shock Travel
85 mm
Rear-Wheel Travel
220 mm

Motor and drivetrain

Motor Type
PMSM
Controller
MTPA/MTPV FOC controller
Peak power
24 kW
Wheel torque
410 N·m
Riding Modes
E / D / S / M / T / R / L
Throttle Range
3 adjustable levels
Battery
78.54 V 45 Ah semi-solid-state battery
Energy Capacity
3.53 kWh
Transmission
Primary gear / secondary chain
Final Drive Chain
520-90 O-ring chain

Performance and charging

Top Speed
90 km/h
Test range at 25 km/h
Up to 160 km
Test range at 40 km/h
Up to 108 km
Charging, 20–80%
2 hours
Charging, 0–100%
4 hours
0–50 km/h
1.8 seconds
0–80 km/h
3.43 seconds

Wheels and tyres

Front Tyre
70/100-19 off-road
Rear Tyre
3.00-18 off-road
Front Wheel
19-inch
Rear Wheel
18-inch

Frame

Frame Material
Forged aluminium alloy
Frame Construction
One-piece forged aluminium-alloy frame

Controls and equipment

Version
Off-road
Traction Control
Yes
Sur-Ron Wheelie Control
2 selectable levels
Coasting Energy Recovery
5 adjustable levels
Braking Energy Recovery
5 adjustable levels
Regenerative Braking
Dedicated RBS trigger
Cruise Control
Available above 10 km/h
Brake Priority / Override Protection
Yes
Tilt Protection
Yes — single-use override available
Side-Stand Protection
Yes — single-use override available
Electrical Protection
High/low temperature and high/low voltage protection
Headlight
3,100-lumen ultra-wide-angle LED
Display
SURRON VISION full-colour TFT
Auto Hold
Yes
Colours
Glacier White, Midnight Black, Desert Brown, Spruce Green

Range figures are manufacturer estimates at the stated test speed. Terrain, rider weight and riding mode affect actual range.